GIGO (Garbage In, Garbage Out)…
I feel SO stupid…
Print started out fine…
But then stopped at the VERY same place it did the last time…
I decided that maybe there was an issue with the actual file. So, I went into my slicer and resaved the g-code file (Hmmmm, strange that the new file is a bit bigger than the old one). I think I now know what the problem is/was; if you get into too much of a rush while saving g-code files within the slicer, and click save before the slicer has completed it’s tasks, you will get a truncated g-code file. That explains the print getting to the exact same place each time and then just stopping. The remaining code wasn’t there to finish the print. So, GIGO (Garbage In, Garbage Out).