Boba Fett v3.0 – 3D Print – Armor, Right Shoulder Bell, Adding Damage

Beat It Up…

Time to make it look battle-worn…

To get the damage positioned correctly, I printed out the paint templates and used a soft pencil to color on the back where the damage spot is. I then drew around the damaged area which transfers the mark to the Shoulder Bell.

Using a soldering iron and a rubber handle of a small hand tool to create the damaged areas on the front…

Damaged areas blocked in.

I then used my Dremel to soften the damaged areas.

Leave a Reply

Your email address will not be published. Required fields are marked *