Boba Fett v3.0 – 3D Print – EE-3, D-Connector & Stock, Holes Drilled

Allowing Them To Stick Together…

Since the two parts fit, let’s get them ready for the screws. When I cut the files up to fit my print bed, it somehow messed up some of the screw holes; they were there on some parts, while gone on others. Time to get them all back in place…

I drilled the first hole through the D-Connector…

I then drilled the first hole through the Stock…

The D-Connector was then placed into position, and a drill bit was used as a screw substitute to keep it from shifting.

I then drilled the second hole, hoping it would come through in the correct spot on the Stock…

And… It did!

Leave a Reply

Your email address will not be published.