Helmet v3.0 – Front Reconstruction, Visor Removal Begins

Getting Rid Of The Ugly Clear Visor

The visor that comes with the helmet is thin, and clear. It appears to be molded into the maroon plastic. This will need to be removed in order to install a more accurate visor.

I began the process by using my dremel to grind away the maroon plastic to try and get down to the clear part.

It’s a very slow process, but it’s getting there…

While the original visor is still intact, I wanted to mark the correct thickness of the mandibles.

A nickel looked about the correct thickness, so I used that along with an exacto knife, to score the plastic around the entire visor.

Leave a Reply

Your email address will not be published. Required fields are marked *