Helmet v3.0 – Rangefinder Polaroid Lens, Basic Prep Starts

Back To The Smoothing Process

The Polaroid lens is another of the 3D printed pieces. Using the process I have been experimenting with on the other 3D printed parts, I will attempt to get it as smooth as an actual found part…

The raw part has a very rough texture.

First step, sand with medium grit sandpaper…

This takes off a bit of the roughness.

Next step, spray on some filler primer. This is the back side.

Once the back was dry, I sprayed the front side.

Leave a Reply

Your email address will not be published. Required fields are marked *