Stock Time…
I was finally able to spend the time needed to repair all of the errors of the stock file so I could cut it into two parts to fit on my build plate. I chose to use PLA+ filament with actual wood fibers for the stock of the Blaster. In order to use this type of filament, I had to swap out the hot end to a larger size to help prevent clogging. I have just been too lazy to make the switch, until today…

After a lot of test runs to get my printer properly calibrated to print with this new filament, I finally started with the smaller part of the stock…

After almost six hours, the first part was done..