Scout Trooper – Boots – Construction, Continued

Let’s Do This…

Now that the glue has dried on the front trim strips, I removed the tape…

Time to finish up the tube parts. I want to “beef” them up a bit, so I’ll be attaching a layer of the thin foam to the inside of each of them…

And using this spray adhesive to hold it in place…

Both tubes now have the sheet foam reinforcements attached…

I once again used painters tape to mask off the areas where I want the glue to stay…

Before I glue the tubes on, I need to trim the excess piece of the front trim strips…

Much better…

The area needing glue is actually a lot smaller than I first thought…

First Boot tube glued and clamped…

And, both Boots now glued and clamped…

Leave a Reply

Your email address will not be published. Required fields are marked *