Scout Trooper – EC-17 Blaster – 3D Printing, Continued

One Cool Blaster…

PET-G is printing well, so let’s keep going…

Beginning the main body of the blaster…

Main body completed.

Beginning to print the cylinder piece that goes on the back area of the blaster.

Upon closer examination, the main body part has some print issues. Most likely due to the way the piece was situated from printing. Rather than taking up a lot of time fixing the sagging, it will probably just be more efficient to re-print it.

Rear cylinder piece, completed, on the build plate.

Beginning printing of the scope bracket.

Scope bracket completed, on the build plate.

Completed scope bracket removed from the build plate.

Bottom hand guard completed, on the build plate.

Finished assembly pins.

Leave a Reply

Your email address will not be published.