Scout Trooper – EC-17 Blaster – Modding, Continued

Making It More Screen Accurate…

Time to work on the hand guard area…

The metal hand guard on the screen used blaster goes further into the bottom of the grip. So, I’m going to simulate that by trimming that area down to match the piece that fits into the square hole…

Looks like it needs to have about 1/16 of an inch removed.

I used my dremel to grind the area down to match the other piece.

The screen used blaster had a screw holding the metal piece to the bottom of the grip. So, I drilled a hole…

Then found a slotted screw that was about the correct size, and super glued it in place.

Hand guard, masked and ready for primer..

Leave a Reply

Your email address will not be published.